PDF Fanuc Power Mate i-D/H Parameter Manual

4. DESCRIPTION OF PARAMETERS
B63180EN/02
34
NOTE
This parameter is valid when ZPI in parameter 1201 is set to
1.
1260 Amount of a shift per one rotation of a rotation axis
NOTE
When this parameter is set, the power must be turned off
before operation is continued.
[Data type] 2word axis
[Unit of data]
Increment system Unit of data Standard value
ISA 0.01 deg 36000
ISB 0.001 deg 360000
ISC 0.0001 deg 3600000
[Valid data range] 1000 to 9999999
Set the amount of a shift per one rotaion of a rotaion axis.

Leave a Reply

Your email address will not be published. Required fields are marked *