PDF Fanuc Power Mate i-D/H Parameter Manual

4. DESCRIPTION OF PARAMETERS
B63180EN/02
36
NOTE
Avoid specifying the relationships in value between the
coordinates of boundaries in the positive and those in the
negative direction in reverse, that is, setting:
Parameter No. 1320 < parameter No. 1321
With this setting, it is assumed that the stroke is infinite, and
storedstroke check 1 is not made. In addition, a coordinate
value can overflow, resulting in the current position not being
displayed correctly or an absolute command failing to move
the tool to the correct position.

Leave a Reply

Your email address will not be published. Required fields are marked *