PDF Fanuc Power Mate i-D/H Parameter Manual

B63180EN/02
4. DESCRIPTION OF PARAMETERS
41
NOTE
1 This parameter is effective only in linear and circular
interpolation. In polar coordinate, the maximum feedrate for
all axes specified in parameter No.1422 is effective.
2 If the setting for each axis is 0, the maximum feedrate
specified in parameter No.1422 is applied to all axes and the
feedrate is clamped at the maximum feedrate.
1431 Maximum cutting feedrate for all axes in the advanced preview control mode
[Data type] 2 Word
[Unit of data]
[Valid data range]
Increment system
Unit of data
Valid data range
I
ncremen
t
sys
t
em
U
n
it
o
fd
a
t
a
IS-A, IS-B IS-C
Millimeter machine 1 mm/min 0 to 240000 0 to 100000
Inch machine 0.1 inch/min 0 to 96000ă 0 to 48000
Rotation axis 1 deg/min 0 to 240000 0 to 100000
Specify the maximum cutting feedrate for all axes in the advanced
preview control mode.
A feedrate in the tangential direction is clamped in cutting feed so that it
does not exceed the feedrate specified in this parameter.
CAUTION
If the current mode is not the advanced preview feed forward
mode, the actual feedrate is clamped at the maximum
cutting feedrate specified in parameter No. 1422 or 1430.
NOTE
To specify the maximum cutting feedrate for each axis, use
parameter No.1432 instead.
1432 Maximum cutting feedrate for each axis in the advanced preview feed forward mode
[Data type] 2 Word axis
[Unit of data]
[Valid data range]
Increment system
Unit of data
Valid data range
I
ncremen
t
sys
t
em
U
n
it
o
fd
a
t
a
IS-A, IS-B IS-C
Millimeter machine 1 mm/min 0 to 240000 0 to 100000
Inch machine 0.1 inch/min 0 to 96000ă 0 to 48000
Rotation axis 1 deg/min 0 to 240000 0 to 100000
Specify the maximum cutting feedrate for each axis in the advanced
preview feed forward mode.
In cutting feed, the actual feedrate for an axis is clamped at such a
maximum feedrate that the maximum cutting feedrate for the axis will not
be exceeded.

Leave a Reply

Your email address will not be published. Required fields are marked *