PDF Fanuc Power Mate i-D/H Parameter Manual

NOTE
To use bellshaped acceleration/deceleration after
interpolation, set this parameter to 0 and select the
acceleration/deceleration using CTBx, bit 1 of parameter
No.1610.
B63180EN/02
4. DESCRIPTION OF PARAMETERS
45
If the time constant expansion function is used, the range of values that
can be set in the parameterspecified cutting feed linear (bellshaped)
acceleration/deceleration time constant (parameter No. 1622 for the
normal mode, parameter Nos. 1635 and 1638 for the highspeed response
mode) and JOG feed linear (bellshaped) acceleration/deceleration time
constant (parameter No. 1624) varies depending on how many controlled
axes are used, as follows:
(a) Normal mode
Number of controlled axes Vaild data range
1 to 2 0 to 32000
3 to 4 0 to 16000
5 to 8 0 to 8000
(b) Highspeed responce mode (Power Mate iH only)
Number of controlled axes Vaild data range
1 to 2 0 to 4000
3 to 4 0 to 2000
5 to 8 0 to 1000
NOTE
The change to this setting takes effect next time the power
is turned on.
#7
1610
#6 #5 #4
JGLx
#3 #2 #1
CTBx
#0
CTLx
[Data type] Bit axis
CTLx Acceleration/deceleration in cutting feed including feed in dry run
0 : Exponential acceleration/deceleration is applied.
1 : Linear acceleration/deceleration after interpolation is applied.
Parameter
CTBx CTLx
Acceleration/deceleration
0 0 Exponential acceleration/deceleration
0 1 Linear acceleration/deceleration after interpolation
1 0 Bellshaped acceleration/deceleration after interpolation
CTBx Acceleration/deceleration in cutting feed including feed in dry run
0 : Exponential acceleration/deceleration or linear acceleration/decel-
eration after interpolation is applied (depending on the setting in
CTLx, bit 0 of parameter No.1610).
1 : Bellshaped acceleration/deceleration after interpolation is applied.
JGLx Acceleration/deceleration in jog feed
0 : Exponential acceleration/deceleration is applied.
1 : Linear acceleration/deceleration after interpolation or bellshaped
acceleration/deceleration after interpolation is applied (depending on
which is used for cutting feed).

Leave a Reply

Your email address will not be published. Required fields are marked *