PDF Fanuc Power Mate i-D/H Parameter Manual

B63180EN/02
4. DESCRIPTION OF PARAMETERS
53
1763
Minimumspeed in exponential acceleration/deceleration for cutting feed in the
advanced preview feed forward mode
[Data type] Word axis
[Unit of data]
[Valid data range]
Increment system
Unit of data
Valid data range
I
ncremen
t
sys
t
em
U
n
it
o
fd
a
t
a
IS-A, IS-B IS-C
Millimeter machine 1 mm/min 6 to 15000 6 to 12000
Inch machine 0.1 inch/min 6 to 6000 6 to 4800
Rotation axis 1 deg/min 6 to 15000 6 to 12000
This parameter is used to set the minimum speed (FL) for cutting feed
exponential acceleration/deceleration in the advanced preview feed
forward mode for each axis.
1768
Time constant for linear acceleration/deceleration during cutting feed in advanced
preview feed forward mode
[Data type] Word
[Unit of data] ms
[Valid data range]
8 to 512
This parameter sets a time constant for linear acceleration/decelerationfor
cutting feed in the advanced preview feed forward mode.
1770
Parameter1 (for advanced preview feed forward) for setting an acceleration for
linear acceleration/deceleration before interpolation (maximum machining speed
during linear acceleration/deceleration before interpolation)
[Data type] 2 Word
[Unit of data]
[Valid data range]
Increment system
Unit of data
Valid data range
I
ncremen
t
sys
t
em
U
n
it
o
fd
a
t
a
IS-A, IS-B IS-C
Millimeter machine 1 mm/min 6 to 240000 6 to 100000
Inch machine 0.1 inch/min 6 to 96000 6 to 48000
This parameter is used to set an acceleration for linear
acceleration/deceleration before interpolation in the advanced preview
feed forward mode. In this parameter, set the maximum machining speed
during linear acceleration/deceleration before interpolation. Set the time
used to reach the maximum machining speed in parameter No.1771.
Speed
Parameter 1
(No.1770)
Parameter 2 (No.1771)
Time

Leave a Reply

Your email address will not be published. Required fields are marked *