PDF Fanuc Power Mate i-D/H Parameter Manual

4. DESCRIPTION OF PARAMETERS
B63180EN/02
56
#7
1800
#6 #5 #4 #3
FFR
#2
OZR
#1
CVR
#0
[Data type] Bit
CVR When velocity control ready signal VRDY is set ON before position
control ready signal PRDY comes ON
0: A servo alarm is generated.
1: A servo alarm is not generated.
OZR When manual reference position return is attempted in the halt state
during automatic operation (feed hold stop state) under any of the
conditions listed below:
0: Manual reference position return is not performed, with P/S alarm
No.091.
1: Manual reference position return is performed without an alarm
occurring.
< Conditions >
(1) When there is a remaining distance to travel.
(2) When an auxiliary function (miscellaneous function, spindlespeed
function, tool function) is being executed.
(3) When a cycle such as a dwell cycle or canned cycle is being executed.
FFR Feedforward control is enabled for
0 : Cutting feed only
1 : Cutting feed and rapid traverse
#7
1801
#6 #5
CIN
#4
CCI
#3 #2 #1 #0
[Data type] Bit
CCI The inposition area for cutting feed is:
0 : Set in parameter No.1826 (same as for rapid traverse).
1 : Set in bit 5 (CIN) of parameter No.1801.
CIN When bit 4 (CCI) of parameter No.1801 = 1, the inposition area for
cutting feed is:
0 : Use value in parameter No.1827 if the next block is also for cutting
feed, or use value in parameter No.1826 if the next block is not for
cutting feed.
1 : Use value in parameter No.1827, regardless of the next block. (The
setting of parameter No.1826 is used for rapid traverse, and the setting
of parameter No.1827 is used for cutting feed.)
4.12
PARAMETERS OF
SERVO

Leave a Reply

Your email address will not be published. Required fields are marked *