PDF Fanuc Power Mate i-D/H Parameter Manual

B63180EN/02
1. DISPLAYING PARAMETERS
1
1
DISPLAYING PARAMETERS
Follow the procedure below to display parameters.
(1) Press the SYSTEM function key on the MDI as many times as
required, or alternatively, press the SYSTEM function key once, then
the PARAM section display soft key. The parameter screen is then
selected.
PARAMETER (FEEDRATE) O0001 N12345
1401 RDR JZR RF0 LRP RPD
0 0 0 0 0 0 0 0
1402 DLF HFC
0 0 0 0 0 0 0 0
1410 DRY RUN FEEDRATE 10000
1411 INIT.CUTTING F 0
1420 RAPID FEEDRATE X 15000
Y 15000
Z 15000
>
AUTO STRT MTN FIN *** 10:02:35
[PARAM] [DGNOS] [ PMC ] [SYSTEM] [(OPRT)]
Cursor
Soft key display
(section select)
POS PROG
OFFSET
SETTING
SYSTEM MESSAGE
GRAPH
Function key
Return menu key Soft key Continuous menu key
CUSTOM
(2) The parameter screen consists of multiple pages. Use step (a) or (b)
to display the page that contains the parameter you want to display.
(a) Use the page select key or the cursor move keys to display the de-
sired page.
(b) Enter the data number of the parameter you want to display from
the keyboard, then press the [NO.SRH] soft key. The parameter
page containing the specified data number appears with the cur-
sor positioned at the data number. (The data is displayed in re-
verse video.)
NOTE
If key entry is started with the section select soft keys
displayed, they are replaced automatically by operation
select soft keys including [NO.SRH]. Pressing the [(OPRT)]
soft key can also cause the operation select keys to be
displayed.
>
AUTO STRT MTN FIN *** 10:02:34
[NO.SRH] [ ON:1 ] [ OFF:0 ] [+INPUT] [INPUT ]
Soft key display
(section select)
Data entered from
the keyboard

Leave a Reply

Your email address will not be published. Required fields are marked *