PDF Fanuc Power Mate i-D/H Parameter Manual

B63180EN/02
4. DESCRIPTION OF PARAMETERS
71
1910 Address conversion table value for slave 1 (ATR)
1911 Address conversion table value for slave 2 (ATR)
1912 Address conversion table value for slave 3 (ATR)
1913 Address conversion table value for slave 4 (ATR)
1914 Address conversion table value for slave 5 (ATR)
1915 Address conversion table value for slave 6 (ATR)
1916 Address conversion table value for slave 7 (ATR)
1917 Address conversion table value for slave 8 (ATR)
1918 Address conversion table value for slave 9 (ATR)
1919 Address conversion table value for slave 10 (ATR)
NOTE
After these parameters have been set, the power must be
turned off then back on for the settings to become effective.
[Data type] Byte
[Valid data range] 0 to 7, 16, 40, 48
These parameters set address conversion table values for slaves 1 to 10.
A slave is the generic name given to a device such as a servo amplifier or
pulse module, connected to the CNC via an FSSB optical cable. Smaller
numbers, starting from 1 are assigned to slaves closer to the CNC; the
maximum number that can be assigned is 10. A twoaxis amplifier has
two slaves, while a threeaxis amplifier has three slaves. Set each
parameter as described below, depending on whether the slave is an
amplifier or pulse module, or when no slave exists.
S When the slave is an amplifier:
Set the value obtained by subtracting 1 from the setting of parameter
No.1023 for the axis to which the amplifier is assigned.
S When the slave is a pulse module:
Set 16
for the first pulse module (closest to the CNC). Set 48 for the
second pulse module (furthest from the CNC).
S When no slave exists
Set 40
.
NOTE
When automatic setting mode is selected for FSSB setting
(when the FMD parameter (bit 0 of parameter No.1902) is set
to 0), parameters No.1910 through No.1919 are automatically
set when input is performed with the FSSB setting screen.
When manual setting 2 mode is selected for FSSB setting
(when the FMD parameter (bit 0 of parameter No.1902) is set
to 1), parameter No.1910 through No.1919 must be directly
set.

Leave a Reply

Your email address will not be published. Required fields are marked *