PDF Fanuc Power Mate i-D/H Parameter Manual

B63180EN/02
4. DESCRIPTION OF PARAMETERS
75
1920 Controlled axis number for slave 1 (dedicated to the FSSB setting screen)
1921 Controlled axis number for slave 2 (dedicated to the FSSB setting screen)
1922 Controlled axis number for slave 3 (dedicated to the FSSB setting screen)
1923 Controlled axis number for slave 4 (dedicated to the FSSB setting screen)
1924 Controlled axis number for slave 5 (dedicated to the FSSB setting screen)
1925 Controlled axis number for slave 6 (dedicated to the FSSB setting screen)
1926 Controlled axis number for slave 7 (dedicated to the FSSB setting screen)
1927 Controlled axis number for slave 8 (dedicated to the FSSB setting screen)
1928 Controlled axis number for slave 9 (dedicated to the FSSB setting screen)
1929 Controlled axis number for slave 10 (dedicated to the FSSB setting screen)
NOTE
After these parameters have been set, the power must be
turned off then back on for the settings to become effective.
[Data type] Byte
[Valid data range] 0 to 8
These parameters are used to set the controlled axis numbers for slaves 1
to 10.
NOTE
These parameters are set using the FSSB setting screen.
So, these parameters should not normally have to be
specified directly. These parameters need not be set in
FSSB manual setting mode.
1931 Connector number for the first pulse module (dedicated to the FSSB setting screen)
1932 Connector number for the second pulse module (dedicated to the FSSB setting screen)
NOTE
After these parameters have been set, the power must be
turned off then back on for the settings to become effective.
[Data type] Byte axis
[Valid data range] 0 to number of connectors provided on each pulse module
When a pulse module is used, these parameters set a pulse module
connector number for each axis.
NOTE
These parameters are set using the FSSB setting screen.
So, these parameters should not normally have to be
specified directly. These parameters need not be set in
FSSB manual setting 2 mode.

Leave a Reply

Your email address will not be published. Required fields are marked *