PDF Fanuc Power Mate i-D/H Parameter Manual

4. DESCRIPTION OF PARAMETERS
B63180EN/02
80
#7 #6 #5 #4 #3
EXDVAL2
#2
DVAL2
#1
EXDVAL1
#0
DVAL1
If each bit is 1, it has the following meaning:
DVAL1: A DO alarm condition was detected in the basic unit in group
1.
EXDVAL1:A DO alarm condition was detected in the expansion unit in
group 1.
DVAL2: A DO alarm condition was detected in the basic unit in group
2.
EXDVAL2:A DO alarm condition was detected in the expansion unit in
group 2.
NOTE
When automatic setting mode is selected for FSSB setting
(when bit 0 of parameter No.1902 is set to 0), these
parameters are automatically set when input is performed
with the FSSB setting screen. When manual setting 2 mode
is selected for FSSB setting (when bit 0 of parameter
No.1902 is set to 1), these parameters must be set directly.
The following parameters are not explained in this manual. Refer to
FANUC AC SERVO MOTOR α Series PARAMETER MANUAL
(B65150E).
No. Data type Contents
2000 Bit axis PGEX PRMC DGPR PLC0
2001 Bit axis AMR7 AMR6 AMR5 AMR4 AMR3 AMR2 AMR1 AMR0
2002 Bit axis VFSE PFSE
2003 Bit axis V0FS OVSC BLEN NPSP PIEN OBEN TGAL
2004 Bit axis DLY0
2005 Bit axis SFCM BRKC FEED
2006 Bit axis DCBE ACCF PKVE FCBL
2007 Bit axis FRCA FAD
2008 Bit axis LAXD PFBS VCTM SPPC SPPR VFBA TNOM
2009 Bit axis BLST BLCU ADBL IQOB SERD
2010 Bit axis HBBL HBPE BLTE LINE
2011 Bit axis RCCL FFALWY SYNMOD
2012 Bit axis STNG VCM2 VCM1 MSFE
2013 Bit axis (Reserve)
2014 Bit axis (Reserve)
2015 Bit axis BLAT TDOU SSG1 PGTW
2016 Bit axis K2VC ABNT
2017 Bit axis PK25 OVCR RISC HTNG DBST
2018 Bit axis PFBC MOVO
2019 Bit axis DPFB
2020 Word axis Motor number
2021 Word axis Load inertia ratio
2022 Word axis Direction of motor rotation

Leave a Reply

Your email address will not be published. Required fields are marked *