PDF Fanuc Power Mate i-D/H Parameter Manual

4. DESCRIPTION OF PARAMETERS
B63180EN/02
86
3017 Output time of reset signal RST
[Data type] Byte
[Unit of data] 16 ms
[Valid data range] 0 to 255
To extend the output time of reset signal RST, the time to be added is
specified in this parameter.
RST signal output time = time veguired for reset + parameter 16 ms
3030 Allowable number of digits for the M code
3031
Allowable number of digits for the S code
3032 Allowable number of digits for the T code
[Data type] Byte
[Valid data range] 1 to 8
Set the allowable numbers of digits for the M, S, and T codes.
NOTE
Up to 5 digits can be specified in the S code

Leave a Reply

Your email address will not be published. Required fields are marked *