PDF Fanuc Power Mate i-D/H Parameter Manual

4. DESCRIPTION OF PARAMETERS
B63180EN/02
88
PPD Relative position display when a coordinate system is set
0 : Not preset
1 : Preset
NOTE
When PPD is set to 1 and the absolute position display is
preset by one of the following, the relative position display is
also preset to the same value as the absolute position display:
1) The manual reference position return
2) Setting of a coordinate system by G92
DRL Relative position
0 : The actual position displayed takes into account tool length offset.
1 : The programmed position displayed does not take into account tool
length offset.
DAL Absolute position
0 : The actual position displayed takes into account tool length offset.
1 : The programmed position displayed does not take into account tool
length offset.
#7
SMF3105
#6 #5 #4 #3 #2
DPS
#1
PCF
#0
DPF
[Data type] Bit
DPF Display of the actual speed on the current position display screen,
program check screen and program screen (MD1 mode)
0 : Not displayed
1 : Displayed
PCF Addition of the movement of the PMCcontrolled axes to the actual speed
display
0 : Added
1 : Not added
NOTE
For each setting, movement along any axis other than those
controlled by the CNC (see the description of parameter No.
1010) is not reflected in the actual speed display.
DPS Actual spindle speed and T code
0 : Not always displayed
1 : Always displayed
SMF During simplified synchronous control, movement along a slave axis is:
0 : Included in the actual speed display
1 : Not included in the actual speed display
(See the parameter No.8311.)

Leave a Reply

Your email address will not be published. Required fields are marked *