PDF Fanuc Power Mate i-D/H Parameter Manual

B63180EN/02
4. DESCRIPTION OF PARAMETERS
93
[Example] When the configuration of axes is X in path 1 and X in path 2
(1) Setting for path 1
Parameter 3131x 65 (A) XA is displayed as axis names.. . .
(2) Setting for path 2
Parameter 3131x 66 (B) XB is displayed as axis names.. . .
#7
3137
#6 #5 #4 #3 #2 #1 #0
TIN
[Data type] Bit
TIN The simultaneous fouraxis teachin function is:
0 : Disabled.
1 : Enabled.
#7
3138
#6
TI7
#5
TI6
#4
TI5
#3
TI4
#2
TI3
#1
TI2
#0
TI1TI8
[Data type] Bit
TIn TIn When the simultaneous fouraxis teachin function is used, the input
address for the nth axis is enabled. The address for the specified axis
number is input.
NOTE
If more than four axes are specified, the first to fourth
lowestnumbered axes are enabled.
3139
Address P for the simultaneous fouraxis teachin function
[Data type] Word axis
[Unit of data] ms
[Valid data range] 0 to 99999999
The value set in this parameter works as address P.
3141 Debice name 1
:
3146 Device name 2
[Data type] Byte
First to sixth equipment name character codes. When the CRT/MDI is
shared by multiple Power Mate units, these equipment names are
displayed on the common screen.
NOTE
With the 2path Power Mate iD, a path name character
code is used. Set these parameters for each path.

Leave a Reply

Your email address will not be published. Required fields are marked *