PROGRAMMING
B–63604EN/01
14. COMPENSATION FUNCTION
191
Executing manual reference position return when tool offset is applied
does not cancel the tool position offset vector. The absolute position
display is as follows, however, according to the setting of bit 4 (LGT) of
parameter No. 5002.
LGT = 0 (Tool geometry compensation is based on shift of the coordinate system.)
Tool geometry
compensation
No option for tool wear com-
pensation or tool figure and wear
compensation
Absolute posi-
tion coordinate
display
Upon manual reference
position return
The shift is reflected. Coordinates
shifted according to tool geometry
compensation are displayed.
The vector is not reflected. The coor-
dinates are displayed as if the offset
had been temporarily canceled.
Next block Coordinates shifted according to tool
geometry compensation are dis-
played.
The vector is reflected.
LGT = 1 (Tool geometry compensation is based on tool movement.)
Tool geometry
compensation
No option for tool wear com-
pensation or tool figure and wear
compensation
Absolute posi-
tion coordinate
display
Upon manual reference
position return
The vector is not reflected. The coor-
dinates are displayed as if the offset
had been temporarily canceled.
The vector is not reflected. The coor-
dinates are displayed as if the offset
had been temporarily canceled.
Next block The vector is reflected. The vector is reflected.
NOTE
Bit 6 (DAL) of parameter No. 3104 is set to 0 (the actual positions to which the tool position offset
is applied are displayed in the absolute position display).
D Manual reference
position return when tool
offset is applied