B–63604EN/01
17. MEMORY OPERATION BY
Series 10/11 TAPE FORMAT
PROGRAMMING
317
For Series 10/11–T, G83 or G83.1 does not cause the tool to dwell. For
the FS10/11 tape format, the tool dwells at the bottom of the hole only if
the block contains a P address.
In Series 10/11–T, G84/G84.2 causes the tool to dwell before the spindle
starts rotating in either the normal or reverse direction, according to the
corresponding parameter setting. For the FS10/11 tape format, when the
block contains a P address, the tool dwells at the bottom of the hole and
at the R position before the spindle starts rotating either in the normal or
reverse direction.
For the FS10/11 tape format, rigid tapping can be specified by using the
methods listed below:
Format Condition (parameter), comment
G84.2 X_ Z_ R_ ...S**** ;
S**** ;
G84.2 X_ Z_ R_ .... ;
Setting (F10/F11) = 1
M29 S**** ;
G84 X_ Z_ R_ .... ;
* Common to Series 21 format
M29 S**** G84 X_ Z_ R_ .... ;
* Common to Series 21 format
G84 X_ Z_ R_ .... S**** ;
G84 is made a G code for rigid tapping.
S**** ;
G84 X_ Z_ R_ .... ;
G84 is made a G code for rigid tapping.
Bit 0 (G84) of parameter No. 5200 = 1
* Common to Series 16 format
Specifying 1 for bit 7 (RDI) of parameter No. 5102 causes the canned
cycle R command diameter or radius programming mode in the FS10/11
tape format to match the diameter or radius programming mode for the
drilling axis.
Specifying bit 3 (F16) of parameter No. 5102 disables the FS10/11 tape
format. This applies only to the canned drilling cycle. However, the
number of repetitions must be specified by using the L address.
CAUTION
Setting bit 3 (F16) of parameter No. 5102 to 1 overrides bits
6 (RAB) and 7 (RDI) of parameter No. 5102; both settings
are assumed to be 0.
It is impossible to use the C–axis (the third axis) as a drilling axis. So,
specifying G18 (ZX plane) generates P/S alarm No. 28 (plane selection
command error).
For the FS10/11 tape format, it is impossible to specify an M code for
clamping the C–axis.
D Dwell with G83 and
G83.1
D Dwelling with G84 and
G84.2
D Rigid tapping
D Diameter or radius
programming
D Disabling the Series
10/11 format
Limitations
D C–axis as the drilling
axis
D Clamping the C–axis