APPENDIXG. ALARM LIST
B–63604EN/01
732
Number ContentsMessage
213 ILLEGAL COMMAND IN
SYNCHRO–MODE
Movement is commanded for the axis to be synchronously controlled.
214 ILLEGAL COMMAND IN
SYNCHRO–MODE
Coordinate system is set or tool compensation of the shift type is
executed in the synchronous control. Correct the program.
217 DUPLICATE G251 (COMMANDS) G51.2 or G251 is further commanded in the polygon machining mode.
Modify the program.
218 NOT FOUND P/Q COMMAND IN
G251
P or Q is not commanded in the G251 block, or the command value is
out of the range. Modify the program.
219 COMMAND G250/G251
INDEPENDENTLY
G251 and G250 are not independent blocks.
220 ILLEGAL COMMAND IN
SYNCHR–MODE
In the synchronous operation, movement is commanded by the NC pro-
gram or PMC axis control interface for the synchronous axis.
221 ILLEGAL COMMAND IN
SYNCHR–MODE
Polygon machining synchronous operation and axis control or balance
cutting are executed at a time. Modify the program.
224 RETURN TO REFERENCE POINT Not returned to reference point before cycle start.
231 FORMAT ERROR IN G10 OR L50 Any of the following errors occurred in the specified format at the pro-
grammable–parameter input.
1 Address N or R was not entered.
2 A number not specified for a parameter was entered.
3 The axis number was too large.
4 An axis number was not specified in the axis–type parameter.
5 An axis number was specified in the parameter which is not an axis
type.
6 An attempt was made to reset bit 4 of parameter 3202 (NE9) or
change parameter 3210 (PSSWD) when they are protected by a
password. Correct the program.
233 DEVICE BUSY When an attempt was made to use a unit such as that connected via the
RS–232–C interface, other users were using it.
239 BP/S ALARM While punching was being performed with the function for controlling ex-
ternal I/O units ,background editing was performed.
240 BP/S ALARM Background editing was performed during MDI operation.
244 P/S ALARM In the skip function activated by the torque limit signal, the number of ac-
cumulated erroneous pulses exceed 32767 before the signal was input.
Therefore, the pulses cannot be corrected with one distribution.
Change the conditions, such as federates along axes and torque limit,
and try again.
245 T–CODE NOT ALOWED IN THIS
BLOCK
One of the G codes, G50, G10, and G04, which cannot be specified in
the same block as a T code, was specified with a T code.
5010 END OF RECORD The end of record (%) was specified.
5020 PARAMETER OF RESTART ERROR An erroneous parameter was specified for restarting a program.
5030 ILLEGAL COMMAND (G100) The end command (G110) was specified before the registration start
command (G101, G102, or G103) was specified for the B–axis.
5031 ILLEGAL COMMAND (G100, G102,
G103)
While a registration start command (G101, G102, or G103) was being
executed, another registration start command was specified for the B–axis.
5032 NEW PRG REGISTERED IN B–AXS
MOVE
While the machine was moving about the B–axis, at attempt was made
to register another move command.
5033 NO PROG SPACE IN MEMORY
B–AXIS
Commands for movement about the B–axis were not registered be-
cause of insufficient program memory.
5034 PLURAL COMMAND IN G110 Multiple movements were specified with the G110 code for the B–axis.
5035 NO FEEDRATE COMMANDED
B–AXIS
A feedrate was not specified for cutting feed about the B–axis.