B–62884EN/01
2. CONFIGURATION AND INSTALLATION OF
PACKAGE
19
(5) Specify the hard disk drive to which the software is to be installed
(Note).
Welcome to Ladder Editing Package.
Setup will place system files into the following drive.
If you want to install these files in a different disk drive,
select the install disk drive.
Ladder Editing Package setup
[] c:[C_DRIVE]
Continue Exit Setup
↓
Install to :
(6) Specify the OPEN CNC interface type. If the OPEN CNC has already
been installed in the personal computer, the installer automatically
identifies the interface type, and the dialog box shown below appears.
If the detected interface type matches that of the Ladder Editing
Package to be installed, click [Ok].
Interface Type 2 is detected.
Ladder Editing Package for Type 2 will be installed.
Ladder Editing Package setup
Ok Cancel
If the OPEN CNC has not yet been installed in the personal computer,
the dialog box shown below appears. Select the interface type of the
OPEN CNC to be installed.
F Interface Type 1
f Interface Type 2
Interface driver is not detected.
Whitch type Interface driver are you want to use ?
Ladder Editing Package setup
Ok Cancel
Interface Type