FANUC Series 16i /18i /21i Additional Manual Page 1

Additional Manual
Edit
Apprv.Desig.
Sheet
Title
Draw
No.
1
/
3
Date
Design
Descri
p
tion
Date
FANUC Series16i/18i/21i–MB, 18i–MB5
Improvement of AI contour control
/ AI nano contour control
040322
A-79490E
Index
1. Specification..................................................................................................................2
2. Parameter .....................................................................................................................3
FANUC Series 16i /18i /21i – MB
FANUC Series 18i – MB5
Improvement of AI contour control / AI nano contour control
( Feedrate control at inch input / mm output )
Specifications

Contents Summary of FANUC Series 16i /18i /21i Additional Manual

  • Page 1FANUC Series 16i /18i /21i – MB FANUC Series 18i – MB5 Improvement of AI contour control / AI nano contour control ( Feedrate control at inch input / mm output ) Specifications Index 1. Specification.....................................................................................................
  • Page 21. Specification During AI contour control / AI nano contour control mode, when a command of rotation axis is specified in inch input, the time constant of acceleration/deceleration becomes 25.4 times compared with that at millimeter input. By this improvement, when the parameter AIH (No.7057#1) is
  • Page 3When parameter AIH (No.7057#1) is set to “1”with inch input and millimeter output during AI contour control / AI nano contour control mode, CNC does the following inch/metric conversion before executing the acceleration/deceleration before interpolation. By this method, CNC controls the acceleration