FANUC Series 30i/31i/32i-A Specification Change of The Shape of FAN Unit Additional Manual Page 1
Additional Manual
TECHNICAL REPORT (MANUAL) ＮＯ．ＴＭＮ ０５／ E
Date Sep,27,2005
General Manager of
CNC Laboratory
FANUC Series 30i/31i/32i-A Specification Change of The Shape of FAN Unit
１．Communicate this report to:
O Your information only
O GE Fanuc-N, GE Fanuc-E
FANUC Robotics
CINCINNATI MILACRON
O Machine tool builder
Sales agency
End user
２．Summary for Sales Documents
A specification change of the shape of FAN unit
３．Notice
４．Attached Document
Drawing
No.
A-65566E
Original section of issue
Vice General
Manager
Department
Manager
Section
Manager
Person in
Charge
ＦＡＮＵＣ
ADE
Contents Summary of FANUC Series 30i/31i/32i-A Specification Change of The Shape of FAN Unit Additional Manual
- Page 1TECHNICAL REPORT (MANUAL) ＮＯ．ＴＭＮ ０５／ E Date Sep,27,2005 General Manager of CNC Laboratory FANUC Series 30i/31i/32i-A Specification Change of The Shape of FAN Unit １．Communicate this report to: O Your information only O GE Fanuc-N, GE Fanuc-E FANUC Robotics CINCINNATI MILACRON O Machine tool builder
- Page 2FANUC Series 30i/31i/32i-A Specification Change of The Shape of FAN Unit Contents The shape of FAN unit for FS30i/31i/32i-A stand-alone basic unit (2 slots) is changed in order to improve the efficiency of radiation of heat. Note that the shape of FAN unit is changed as follows. From September 2005,