FANUC Series 16i/18i/21i Additional Manual Page 3
Additional Manual
Edit
Apprv. Desig.
Sheet
Title
Draw
No.
Date
Design
Descri
p
tion
Date
FANUC Series 16i /18i /21i –B, 18i –
MB5
Bit parameter entry by G10 command
S ifi ti
May.27.2004
T.Inagaki
3/5
A-79612E
1 OUTLINE
In case that the parameter G1B (No.3454#4) is set to 1, the bit type parameter
can be changed by G10 command.
Format
Format
G10L50 ;
N_Q_R_ ;
N_P_Q_R_ ;
：
：
G11 ;
Parameter entry mode setting
For bit parameters other than the axis type
For bit parameters of axis type
Parameter entry mode cancel
Meaning of command
N_ : Parameter number (5 digids)
R_ : Parameter setting value (0 or 1)
Q_ : Bit number 0 to 7
P_ : Axis number 1 to 8
Explanations
・Bit number (Q_)
・Parameter setting value (R_)
Do not use a decimal point in a value set in (Q_) and (R_)
If decimal point is commanded in these fields, P/S alarm (No.007) is generated.
・Axis number (P_)
Specify an axis number (P_) from 1 to 8 (up to eight axes) for an axis type
parameter. The control axes are numbered in the order displayed on the CNC
screen.
For example, specity P2 for the control axis which is displayed second.
WARNING
The canned–cycle mode must be cancelled before entering of parameters.
When not cancelled, the drilling motion may be activated.
NOTE
Other NC statements cannot be specified while in parameter input mode.
Contents Summary of FANUC Series 16i/18i/21i Additional Manual
- Page 1FANUC Series 16i /18i /21i – B , 18i – MB5 Bit parameter entry by G10 command Specification FANUC Series 16i /18i /21i –B, 18i – Title MB5 Bit parameter entry by G10 command Draw S ifi ti No. A-79612E Edit Date Design Description Sheet 1/5 Date May.27.2004 Desig. T.Inagaki Apprv.
- Page 2- Contents - 1 OUTLINE............................................................................................................................... 3 2 PARAMETERS...................................................................................................................... 5 FANUC Series 16
- Page 31 OUTLINE In case that the parameter G1B (No.3454#4) is set to 1, the bit type parameter can be changed by G10 command. Format Format G10L50 ; Parameter entry mode setting N_Q_R_ ; For bit parameters other than the axis type N_P_Q_R_ ; For bit parameters of axis type ： ： G11 ; Parameter entry mode c
- Page 4Example 1. Setting the Bit parameter SBP (No.3404#2) G10 L50 ; Parameter entry mode setting N3404 Q2 R1 ; Set bit parameter SBP(No.3404#2) to “1” G11 ; Parameter entry mode cancel 2. Setting the Bit axis type parameter MIRx(No.0012#0) of Z axis (3rd axis) and A axis (4th axis) G10 L50 ; Parameter en
- Page 52 PARAMETERS #7 #6 #5 #4 #3 #2 #1 #0 3454 G1B [Data type] Bit G1B In programmable paraemter entry, the bit type parameter entry is 0: Not available 1: Available (Bit nuber is specified by Q_) FANUC Series 16i /18i /21i –B, 18i – Title MB5 Bit parameter entry by G10 command Draw S ifi ti No. A-79612E