FANUC Series 30i/31i/32i, The Memory Protection Signal for CNC Parameter Additional Manual Page 3
Additional Manual
A-90150E
Title
3/3
page
FANUC Series 30i /31i /32i
The memory protection signal for
CNC parameter
Ed.
Date
Design
Description
Apprv.
Design.
Date
Nov.21.’05
Draw
No.
#7 #6 #5 #4 #3 #2 #1 #0
8900
PWE
[Input type] Setting input
[Data type] Bit system common
# 0 PWE
The setting, from an external device and MDI panel, of those parameters
that cannot be set by setting input is :
0: Disabled.
1: Enabled.
NOTE
This parameter is effective when the parameter
PKY(No.3299#0)=0.
Note
・ When the parameter PKY(No.3299#0)=1, the setting of “Parameter write” on the setting
screen is unavailable.
・ In case of the parameter PKY(No.3299#0)=1 and PWE(No.8900#0)=0 at power turn-on
and the signal KEYP<G046.0> set to "1" in the operation mode, the alarm SW0100
occurs and operation stops.
Contents Summary of FANUC Series 30i/31i/32i, The Memory Protection Signal for CNC Parameter Additional Manual
- Page 1FANUC Series 30i /31i /32i The memory protection signal for CNC parameter Specifications FANUC Series 30i /31i /32i Title The memory protection signal for CNC parameter Draw No. A-90150E Ed. Date Design Description page 1/3 Date Nov.21.’05 Design. Apprv.
- Page 2Overview By using this function, the “Enable” or “Disable” setting of “Parameter write” can be set by the signal. The switch of enable or disable of this function is set by the parameter PKY(No.3299#0), and the switch of enable or disable setting of input parameter is set by the signal KEYP
. - Page 3#7 #6 #5 #4 #3 #2 #1 #0 8900 PWE [Input type] Setting input [Data type] Bit system common #0 PWE The setting, from an external device and MDI panel, of those parameters that cannot be set by setting input is : 0: Disabled. 1: Enabled. NOTE This parameter is effective when the parameter PKY(No.3299#0