1. Fanuc
  2. Pointing Device, Connection Manual

Pointing Device, Connection Manual Additional Manual Page 1

Additional Manual
Edit Date Design Description
SHEET
FANUC LTD
1/6
Pointing Device
Connection Manual
Contents
page
1. Overview 2
2. Order specification 2
3. Environment 2
4. Power specification 2
4.1 Absolute maximum rating 2
4.2 Recommended operation condition 2
5. Connector 3
6. Connection 3
7. External dimension 4
8. Panel cut drawing 5
9. Stud installation position 5
10. Assembling method 6
01 04/10/15 Nogami First issue
A-85113E
CUST.DRWAING NO.
TITLE
Pointing Device
Connection Manual
Previous page
Next page

Contents Summary of Pointing Device, Connection Manual Additional Manual

  • Page 1Pointing Device Connection Manual Contents page 1. Overview 2 2. Order specification 2 3. Environment 2 4. Power specification 2 4.1 Absolute maximum rating 2 4.2 Recommended operation condition 2 5. Connector 3 6. Connection 3 7. External dimension 4 8. Panel cut drawing 5 9. Stud installation posi
  • Page 21. Overview This manual describes the specification of Pointing Device. 2. Order specification Name Order specification Pointing device A02B-0303-K200 Cable for pointing device A08B-0084-K803 3. Environment Item Condition Ambient 0 ∼ +45°C temperature (Operating) Ambient -15 ∼ +60°C temperature (Non
  • Page 35. Connector Pin No. Signal name 1 5 1 Data 2 Clock 3 GND 4 Vcc 5 (FG) Connector specification : B5B-PH-SM3-TP (J.S.T Mfg Co.,Ltd) 6. Connection Pointing device Connect to the rear connector. (CN1) PC side mouse connector Cable for pointing device Note 1. The specification of the mouse connector PS/
  • Page 47. External dimension (unit : mm) 8-φ6.20 The diameter of the rubber’s hole CN1 (rear side) Right bottom left bottom 8-φ3.60 Label position (rear side) The diameter of the PCB’s hole TITLE DRWAING NO. A-85113E CUST. Edit Date Design Description FANUC LTD SHEET 4/6
  • Page 58. Panel cut drawing (unit : mm) 50 10 10 R8 φ23 16 R3 2 9. Stud installation position (unit : mm) The studs have not to be removed up to the torque 1.2N.m. Male stud for M3 (length：8mm) 20 24 28 24 TITLE DRWAING NO. A-85113E CUST. Edit Date Design Description FANUC LTD SHEET 5/6
  • Page 610. Assembling method (unit : mm) The pointing device is assembled to the plate with eight nuts for M3. (torque 0.8N.m) Pointing device M3 Nut Spacer CN1 0.45∼0.8 (Spacer thickness) Spacer measure Spacer φ5.60∼φ6.00 (External diameter of spacer) φ6.20 (Oil resistant sheet diameter) TITLE DRWAING NO.