FANUC Open CNC The limetations of the specifications for FOCAS1/Ethernet Additional Manual Page 1
Additional Manual
1
/
2
Ed.
Recog.
Desi
g
Date Desi
g
DESCRIPTION
DATE
99/05/24 Kubo
01 98/05/24 Kubo New creation
FANUC Open CNC
The limitations of the specifications for
FOCAS1/Ethernet
A-77780E/01
Drawin
g
No.
Title
Sheet
TECHNICAL REPORT No. TMN99/049E
Date May.24.1999
General Manager of
Application Software
Development Department
FANUC Open CNC
The limitations of the specification for FOCAS 1/ Ethernet
1. Communicate this report to:
O Your information
O GE Fanuc-N, GE Fanuc-E
FANUC Robotics
CINCINNATI MILACRON
O Machine tool builder
Sales agency
End user
2. Summary for Sales Documents
3. Notice
4. Attached Document
Drawing
No.
A-77780E/01
5. Registration of Order List data (In case of Order List)
Type of data
IDE
Ori
g
inal section of issue
General
Mana
g
e
r
Charge
Section
Person in
Contents Summary of FANUC Open CNC The limetations of the specifications for FOCAS1/Ethernet Additional Manual
- Page 1TECHNICAL REPORT No. TMN99/049E Date May.24.1999 General Manager of Application Software Development Department FANUC Open CNC The limitations of the specification for FOCAS 1/ Ethernet 1. Communicate this report to: O Your information O GE Fanuc-N, GE Fanuc-E FANUC Robotics CINCINNATI MILACRON O Ma
- Page 2FANUC Open CNC The limitations of the specifications for FOCAS1/Ethernet In the FOCAS1/Ethernet, there are the following limitations as compared to FOCAS1/HSSB. So, be careful to them when using the FOCAS1/Ethernet. 1. In the FOCAS1/Ethernet, you cannot operate BOOT/IPL functions from PC side. In ot