
EDT
rvPersn
DATE
DESIG.
DESCRIPTION
Date
FANUC Series 30i/31i/32i-A, 31i-A5
Inverse time feed for the lathe system
A-90215EN
5/6
Name No.
Page
FANUC LTD.
NOTE
1 In the inverse time specification mode, an F code is not handled as a
modal code and therefore needs to be specified in each block. If an F
code is not specified, alarm (PS1202 (NO F COMMAND AT G93)) is
issued.
2 When F0 is specified in inverse time specification mode, alarm (PS0011
(FEED ZERO (COMMAND))) is issued.
3 Inverse time feed cannot be used when PMC axis control is in effect.
4 If the calculated cutting feedrate is smaller than the allowable range,
alarm (PS0011 (FEED ZERO (COMMAND))) is issued.
Explanations
- For linear interpolation (G01)
distance
feedrate
time
FRN ==
(min)
1
For metric input: feedrate(mm/min), distance(mm)
For inch input: feedrate(inch/min), distance(inch)
- To end a block in 1(min)
0.1
(min)1(min)
1
===
1
time
FRN
- Specify F1.0.
- To end a block in 10(sec)
0.6
(sec)10
(sec)60
(sec)
(sec)60
===
time
FRN
- Specify F6.0.
- To find the movement time required when F0.5 is specified
0.2
5.0
1
(min) ===
1
FRN
TIME
- 2(min) is required.