1. Fanuc
  2. FANUC Series 16i/18i/21i -TB/MB Spindle Speed Override for Each Spindle (Improvement of Multi-Spindle Control)

FANUC Series 16i/18i/21i -TB/MB Spindle Speed Override for Each Spindle (Improvement of Multi-Spindle Control) Additional Manual Page 1

Additional Manual
A-79118E
Edit
Apprv. Desig.
Sheet
Title
Draw
No.
Date
Design
Descri
p
tion
Date
FANUC Series 16i/18i/21i –TB/MB
Spindle speed override for each spindle
(Improvement of multi-spindle)
Sheet
1
/
5
FANUC Series 16i/18i/21i -TB/MB
Spindle speed override for each spindle
(Improvement of multi-spindle control)
Specifications
Previous page
Next page

Contents Summary of FANUC Series 16i/18i/21i -TB/MB Spindle Speed Override for Each Spindle (Improvement of Multi-Spindle Control) Additional Manual

  • Page 1FANUC Series 16i/18i/21i -TB/MB Spindle speed override for each spindle (Improvement of multi-spindle control) Specifications FANUC Series 16i/18i/21i –TB/MB Title Spindle speed override for each spindle (Improvement of multi-spindle) Draw A-79118E No. Edit Date Design Description Sheet 1/5 Date Des
  • Page 21.General During this function, each spindle speed can be overridden individually. An override value to 0%~254% can be applied. This function can be used when multi-spindle control type C (parameter MSC (No.3713#3)) is set. This function requires multi-spindle control option. 2.Specification When ea
  • Page 3SOV0#2~7#2 SOV0#1~7#1 1st spindle#2 override override 1st spindle#1 S command SOV20#2~27#2 SOV20#1~27#1 2nd spindle#2 override override 2nd spindle#1 SOV30#2~37#2 SOV30#1~37#1 path 2 path 1 3rd spindle#2 override override 3rd spindle#1 Fig.4 Parameter EOV(No.3713#4)=1 (two-path) 3.Signals Spindle sp
  • Page 44.Parameter #7 #6 #5 #4 #3 #2 #1 #0 3713 EOV [Data type] Bit, common to all path EOV Each spindle speed override is 0: not used 1: used NOTE 1) Multi-spindle control type C (No.3713#3=1) is necessary to use this function. NOTE 2) When this parameter has been set, the power must be turned off before
  • Page 55.Note - The multi-spindle control option is necessary to use this function. - In the case of parameter SOV (No.3106#5) (the spindle override value is displayed)=1, 1st spindle speed override value is displayed. - During constant surface speed control, the spindle speed is overridden after it is cla