Dust collection unit for FANUC LASER C2000E, C4000E Additional Manual Page 1

Additional Manual
TECHNICAL REPORT(MANUAL) NO. TML 03/003E
Date 24 June, 2003
General Manager of
Laser Laboratory
The modification for improvement of reliability
and maintainability
1. Communicate this report to:
Your information only
GE Fanuc-N, GE Fanuc-E
FANUC Robotics
MILACRON
Machine tool builder
Sales agency
End user
2. Summary for Sales Documents
3. Notice
This report announces the improvement reliability and maintainability parts in laser C series
Please confirm the price of these parts as maintenance parts or as additional parts for a shipped
laser.
4. Attached Document
Drawing
NO.
A81053E034
A81053E035
A81053E037
IDE
Original section of issue
Vice-General
Manager
Department
Manager
Person in
Charge
FANUC

Contents Summary of Dust collection unit for FANUC LASER C2000E, C4000E Additional Manual

  • Page 1TECHNICAL REPORT(MANUAL) NO. TML 03/003E Date 24 June, 2003 General Manager of Laser Laboratory The modification for improvement of reliability and maintainability 1. Communicate this report to: ○ Your information only ○ GE Fanuc-N, GE Fanuc-E FANUC Robotics MILACRON ○ Machine tool builder Sales age
  • Page 2Dust collection unit for FANUC LASER C4000-MODEL E and C2000-MODEL E 1. Abstract The dust collection unit was added for the improvement of reliability and maintainability of C4000-E and C2000-E. Because the dust of the particulate in the resonator can be divided by the centrifugal force, the laser g
  • Page 33. Structure The dust box is arranged under the gas flow circuit, and dust is collected here. It is not necessary to maintain the dust box usually. However, please remove the dust box and the slit as shown in the figure below, and clean the inside of the dust box when a large amout of dust is genera
  • Page 44. Change in tube pressure for oscillation In C2000-E, to prevent the power decrease because of the dust collection unit addition, tube pressure for oscillation was changed from 66Torr to 68Torr. The changed parameters are as follows. PRM15242(Tube pressure for oscillation 50Hz) 660→ 680 PRM15243(Tu
  • Page 5Note) When you exchange the turbo blower, please remove the filter form the turbo blower installed the laser oscillator, and install this filter in the turbo blower for the exchange. Installed Returning turbo blower turbo blower Laser oscillator Filter 2) Installing filter Installed Installed Turbo
  • Page 66. Application (1) Dust collection unit The dust collection unit is applied from following oscillator. C4000-E L02740475 (Manufacturing in 2002 in July) Note) The change of turbo blower filter is applied at the same time. C2000-E L02Z20684~L02Z20689, L02Z20692, L02Z20693 (Manufacturing in 2002 Decem