1. Fanuc
  2. Changing BIOS Setting in the Fanuc Open CNC (A-76035E/01)

Changing BIOS Setting in the Fanuc Open CNC (A-76035E/01) Additional Manual Page 5

Additional Manual
About the BIOS standard setting value
The BIOS setting value that is set by BIOS program automatically is called “the BIOS
default setting value”. FANUC changes with regard to the item that was shown in the table of
the next page to “the BIOS default setting value”. The BIOS setting value of factory shipment
is called “the BIOS standard setting value”. BIOS returns setting values to “the BIOS default
setting value” in the case that the setting value is lost cause the fall of battery voltage. In this
case, please change the value of the item of the following table to “the BIOS standard setting
value”.
The BIOS standard setting value (In case of the New MMC-IV）
Item of the setup utility The BIOS default setting value
The BIOS standard setting
value
Date and Time
Not set automatically
→
Please set date and time.
Start Options
Automatic Configurations
Disable
→
Enable
PCMCIA ATA Card
Enable
→
Disable*
Power Management
IDE Standby Timer
Disable
→
10 min
*) We do not mind even if the setting value of the item of PCMCIA ATA Card is which of Enable
or Disable because there is not a PCMCIA slot on the New MMC-IV. When it is set up to
Disable, a booting time of the New MMC-IV is shortened about several seconds.
EDIT.
FANU
C
LTD
FANUC LTDFANUC LTD
FANU
C
LTD
SHEET
DRAW. NO.
CUST.
TITLE
004/
DESCRIPTIONDESIG.DATE
Changing BIOS setting
in the FANUC OPEN CNC
A
-76035E/01
Previous page
Next page

Contents Summary of Changing BIOS Setting in the Fanuc Open CNC (A-76035E/01) Additional Manual

  • Page 1
  • Page 2Changing BIOS setting in the FANUC OPEN CNC Outline The power management of the HDD (Hard Disk Drive) in the FANUC OPEN CNC system such as MMC-IV, Intelligent Terminal, Series 160i/180i/210i is controlled by the BIOS software (Basic Input Output System). In accordance with present BIOS setting value
  • Page 3(C) Copyright IBM Corporation 1981,1994 ALL RIGHTS RESERVED ~~~~ ~~ 486DX2-50MHz ~~~~ ~~ ~~~~ ~~ Copyright (C) Matsushita Electric Industrial Co.,LTD 1995 Release 01 2.00 0640KB System Memory Please push “F1” key while this 7168KB Extended Memory rectangle is displayed. The Setup utility is started.
  • Page 42. Confirming the hard disk capacity 1) Please move the cursor to “System Summary” of the menu screen and push the [Enter] key. 2) After confirming the item of “Hard Disk Drive 0” is displayed like the list shown below, please go to the next step; “Changing the setting value”. In the case that the v
  • Page 5About the BIOS standard setting value The BIOS setting value that is set by BIOS program automatically is called “the BIOS default setting value”. FANUC changes with regard to the item that was shown in the table of the next page to “the BIOS default setting value”. The BIOS setting value of factory
  • Page 6Technical Notice 1. Please set the Doze Timer setting and also Sleep Timer setting of the setup utility just as Disable. 2. In the case that the IDE Standby Timer setting of the setup utility is set to “10 min”, when it passes for about 10 minutes without the access to the HDD being carried out, the