3. INTERPOLATION FUNCTIONS
B–63682EN/01
NC FUNCTION
24
Positioning is done with each axis separately (Non linear interpolation
type positioning).
Any of the following tool paths can be selected using parameters.
D Non linear interpolation positioning
Each axis is independently positioned at the rapid traverse rate, then
punch is performed. The tool path is normally straight.
D Linear interpolation–type positioning
Positioning is performed within the shortest possible time by moving
along a straight line to a specified point at a speed not higher than a
rapid traverse rate for each axis.
Non linear interpolation
positioning
End position
Start position
Linear interpolation–type positioning
It is decelerated, to a stop at the end point, and imposition check is
performed (checks whether the machine has come to the specified
position). The in-position check can be suppressed using a parameter.
Width of imposition can be set as a parameter.
G00 _ ;IP
3.1
POSITIONING (G00)
Format