1. Fanuc
  2. Connecting and Maintenance Manual for Fanuc Intelligent Terminal (A-72891E/03)

Connecting and Maintenance Manual for Fanuc Intelligent Terminal (A-72891E/03) Additional Manual Page 1

Additional Manual
TECHNICAL REPORT (MANUAL)

Date1998
General Manager of
Hardware Laboratory
Connecting and Maintenance Manual for FANUC Intelligent Terminal
Communicate this report to:
○ Your information only
○ GE Fanuc-N, GE Fanuc-E
FANUC Robotics
CINCINNATI MILACRON
○ Machine tool builder
Sales agency
End user
Summary for Sales Documents
(Sales guide, Functional comparison list, etc.)
Notice
There were misleading expressions in the previous editions of this manual. These expressions are
modified in this edition. Please replace the sheets of 1, 11 and 12 in the previous edition with new
sheets attached to this report.
Attached Document
Drawing
No.
FANUC Intelligent Terminal
Connecting and Maintenance Manual
03 Edition
(1,11,12/43)
Original section of issue
General
Manager
Department
Manager
Section
Manager
Person in
Charge

IDEO
Previous page
Next page

Contents Summary of Connecting and Maintenance Manual for Fanuc Intelligent Terminal (A-72891E/03) Additional Manual

  • Page 1TECHNICAL REPORT (MANUAL) Date 1998 General Manager of Hardware Laboratory Connecting and Maintenance Manual for FANUC Intelligent Terminal Communicate this report to: ○ Your information only ○ GE Fanuc-N, GE Fanuc-E FANUC Robotics CINCINNATI MILACRON ○ Machine tool builder Sales agency End user Sum
  • Page 2INTRODUCTION This manual describes the connecting information of the Fanuc Intelligent Terminal Type 1 function (I.T.) of the following FANUC CNC. This manual also provides maintenance information (block diagrams and drawing numbers of printed circuit board(PCB), etc.). Use this manual together with
  • Page 3••••Floppy Disk Drive (Signal & Power) Intelligent Term inalType 3.5” Floppy D isk D rive A ‚‚b‚ cR‚ S 1 0V 2 D E N SE L 1 0V 2 D E N SE L 3 0V 4 3 0V 4 5 0V 6 5 0V 6 7 0V 8 *IN D E X 7 0V 8 *IN D E X 9 0V 10 *M T0 9 0V 10 *D S0 11 0V 12 *D S1 11 0V 12 *D S1 13 0V 14 *D S0 13 0V 14 (R eserve) 15 0V
  • Page 4Cable Wiring JD 8 J1 1 1 1 0V 0V 2 2 2 D E N SE L D E N SE L 3 3 3 0V 0V 4 4 4 (N C ) (N C ) 5 5 5 0V 0V 6 6 6 (N C ) (N C ) 7 7 7 0V 0V 8 8 8 *IN D EX *IN D EX 9 9 9 0V 0V 10 10 16 *M T0 *D S0 11 11 15 0V 0V 12 12 14 *D S1 *D S1 13 13 13 0V 0V 14 14 12 *D S0 (R eserve) 15 15 11 0V 0V 16 16 10 Panne