The Step3 of FANUC Series 15i-MA/150i-MA is released.
The following information is described here.
- The features which are added or enhanced in the Step3
- The revisions of the manuals for the specifications of the features
1.1 The series applied for the Step3
(*1) As for the editions of the series, all the features of the Step3 are possible from the fiest
(*2) Corresponding Software series of Step1 and Step2 means the series which can be
replaced by the corresponding series of the Step3.
1.2 Corresponding documents
The rough specifications of the features are described on 2. of this report.
As for the specifications in detail, refer to the attached documents prepared for the next
revision of the manuals.
And, as to the revision of the manuals, additions and modifications of the features of the
Step1 and Step2 for the next revision are also described.
No. Series Software series
of Step1 and
F603 F601,F602 For multi-axis
FANUC Series 15i-MA/150i-MA
Ver Date Design Description
01 99.08.05 Sano