Changing of the gas piping for Fanuc Laser C1000-Model E Additional Manual Page 3
Additional Manual
TITLE
DRAW.
No.
Changing of gas piping for
FANUC LASER C1000-MODEL E
A-81053E-015
【Note】
Clean the seal surface, and check that there are no scratches on the surface.
The torque tightening the "NEW1" is about 45[N m]
The torque tightening the "NEW2" is about 40[N m]
(These data are adapted only to the first tightening)
Tightening with a quite weak torque, it would make a seal performance worse.
Tightening with a quite strong torque, it would make the fitting broken.
【Confirmation】
After 10 minutes of vacuum pumping, confirm that DGN 905=LASER TUBE PRES. is
less than 10(After this confirmation, you may do the usual leak check continuously.).
【Application】
FANUC LASER C1000-MODEL E manufactured in August 2001
2 / 2
Page
FANUC LTD
DESCRIPTION DESIGN DATE
EDIT
New registration MIYAKE 20010803 01
Contents Summary of Changing of the gas piping for Fanuc Laser C1000-Model E Additional Manual
- Page 1TECHNICAL REPORT (MANUAL) NO. TML01/006E Date: Aug/16 /2001 General Manager of LASER Laboratory Changing of the gas piping for FANUC LASER C1000-MODEL E 1. Communicate this report to: 〇 Your information only 〇 GE Fanuc-N, GE Fanuc-E FANUC Robotics MILACRON Machine tool builder Sales agency End user
- Page 2Changing of gas piping for FANUC LASER C1000-MODEL E 【Overview】 In order to improve an operation, we changed a specification of a fitting connecting between an oscillator and an exhaust pump, used on the exhaust pump side. We would announce a new gas piping method as follow. Old method New method Ti
- Page 3【Note】 Clean the seal surface, and check that there are no scratches on the surface. The torque tightening the "NEW1" is about 45[N m] The torque tightening the "NEW2" is about 40[N m] (These data are adapted only to the first tightening) Tightening with a quite weak torque, it would make a seal per