B–63284EN/03
2. MACHINING PROGRAMS FOR
LATHES WITH C–AXIS
TYPES OF MACHINING
PROGRAMS
405
(1) Figure data when EQUAL is specified as the hole interval
STAT–PX : X–coordinate of a hole start position (common)
STAT–PZ : Z–coordinate of a hole position (common)
STAT–PC : C–coordinate of the first hole position
NOTE
In drilling, cutting starts at a point which allows for a drilling
clearance (parameter 9855: GRDCL).
Drilling clearance (parameter 9855:
GRDCL)
Machining start point
X–coordinate of a hole start point
Hole depth
(radius)
DEPTH : Hole depth (Radius:Common)
ANGLE : Angle subtended by consecutive holes
Either the positive or negative direction can be
specified.
NUMBER : Total number of holes
LST.ANGL : C–coordinate of the last hole position
1 When neither A (angle), N (number of holes), nor EC (final angle)
is entered
Example) C = 90.000
C = 0
2.2.3
Details of Figure Data