A. PARAMETERS
B–63284EN/03
APPENDIX
762
6510 Drawing coordinate system: GRPAX
GRPAX: Drawing coordinate system in the graphic function (Set the value each tool
post)
D Only the following values are valid for tool post 1 of the 1–path lathe
and tool post 1 of the 2 turrets lathe with facing two spindles.
1 : The program reference position is on the chuck end surface and only
the upper half of the material is displayed.
11: The program reference position is on the chuck end surface and the
upper and lower sides of the material are displayed.
4 : The program reference position is on the workpiece end surface and
only the upper half of the material is displayed.
14: The program reference position is on the workpiece end surface and
the upper and lower sides of the material are displayed.
X
GRPAX=1
Z
X
GRPAX=11
Z
X
Z
GRPAX=4
GRPAX=14
X
Z
D Only the following values are valid for tool post 2 of the 2 turrets lathe
with facing two spindles.
21: The program reference position is on the chuck end surface and only
the upper half of the material is displayed.
31: The program reference position is on the chuck end surface and the
upper and lower sides of the material are displayed.
24: The program reference position is on the workpiece end surface and
only the upper half of the material is displayed.
34: The program reference position is on the workpiece end surface and
the upper and lower sides of the material are displayed.