FANUC Series 16i/18i MA Digitizing function Additional Manual Page 1

Additional Manual

Page of 7

/ 7

2000/07/21 H. Shiobara

A-78209EN

FS16i/18i-MA

Digitizing function

Title

Drawing No.

Page

Descri

tionDateEdit

1/7

1.1.

1. SPECIFICATIONS

SPECIFICATIONSSPECIFICATIONS

SPECIFICATIONS ................................

................................................................

............................................................

........................................................

............................2

1.1. O

UTLINES

....................................................................................................................................2

1.2. D

ETAILS

.......................................................................................................................................3

1.3. R

ESTRICTIONS

.............................................................................................................................3

2.2.

2. PARAMETERS

PARAMETERSPARAMETERS

PARAMETERS ................................

................................................................

..................................

....

..4

3.3.

3. APPLICABLE SOFTWA

APPLICABLE SOFTWAAPPLICABLE SOFTWA

APPLICABLE SOFTWARE

RERE

RE ................................

................................................................

..............................................

............................

..............7

FANUC Series 16

/18

-MA

Digitizing function

Specifications

Contents Summary of FANUC Series 16i/18i MA Digitizing function Additional Manual

Page 1FANUC Series 16i/18i-MA Digitizing function Specifications 1. SPECIFICATIONS ................................................................ ................................................................................................ .............................................................
Page 21.Specifications 1.1.Outlines The sum of position feedback (moving amount) of servo axes and digitizing probe since power-up can be detected and read via FOCAS1/HSSB. We call, in this documents, “the sum of position feedback” for the moving amount of servo axis (detection unit) since power-up, and “
Page 31.2.Details In this function, the feedback of servo motor is input to servo amplifier and the feedback (A/B phase type) of digitizing probe is input to separate detector interface unit, and CNC reads these data via FSSB and FOCAS1 can read them via window function. CNC checks whether FOCAS1 requests
Page 42.Parameters Following parameters for each axes corresponding to each directions of probe moving are set for reading the feedback of digitizing probe. Normally, the parameters for X/Y/Z axes are set for reading the feedback of probe moving in X/Y/Z direction. NOTE After these par
Page 5connectors, start from that connector having the smallest connector number. For example, connector number 4 cannot be used if connector number 3 is not being used. Data type: Bit axis SSS The sum of feedback via the separate detector interface unit is: 0: not calculated. 1: calcula
Page 6Example of parameter settings The machine with 3 axes (X, Y and Z axis), 3-axes amplifier, and the sum of position feedback and the sum of feedback via the separate detector interface unit for all axes are read. 1902#0 No. FMD 1 No. 1910 1911 1912 1913 1914~1919 0 1 2 16 40 1905#0 1905#6 1905#7 2016
Page 73.Applicable software Following system software is required for this function. FS16i-MA B0F2-xx or later FS16i-TA B1F2-xx or later FS18i-MA BDF2-xx or later FS18i-TA BEF2-xx or later Following servo software is required for this function Servo 90A0-xx or later Title FS16i/18i-MA Digitizing function