1. Fanuc
  2. Change of the DeviceNet board specification in FS16i/18i/21i/160i/180i/210i/160is/180is/210is-MODEL A/B and Power Mate i-MODEL D/H

Change of the DeviceNet board specification in FS16i/18i/21i/160i/180i/210i/160is/180is/210is-MODEL A/B and Power Mate i-MODEL D/H Additional Manual Page 1

Additional Manual
TECHNICAL REPORT (MANUAL) NO. TMN03/051E
Date 10 Jun, 2003
General Manager of
CNC Laboratory
Change of the DeviceNet board specification in
FS16i/18i/21i/160i/180i/210i/160is/180is/210is-MODEL A/B and
Power Mate i-MODEL D/H
1. Communicate this report to :
○
Your information
○
GE Fanuc-N, GE Fanuc-E
FANUC Robotics
CINCINNATI MILACRON
○
Machine tool builder
Sales agency
○
End user
2. Summary for Sales Documents
3. Notice
4. Attached Document
Drawing No. A-77221EN Edition 01 (1/4 ~ 4/4)
No.CLB6-03/6076
10 Jun, 2003
Order section of issuer of issue
ADE V.G.M. Manager Chief
Previous page
Next page

Contents Summary of Change of the DeviceNet board specification in FS16i/18i/21i/160i/180i/210i/160is/180is/210is-MODEL A/B and Power Mate i-MODEL D/H Additional Manual

  • Page 1TECHNICAL REPORT (MANUAL) NO. TMN03/051E Date 10 Jun, 2003 General Manager of CNC Laboratory Change of the DeviceNet board specification in FS16i/18i/21i/160i/180i/210i/160is/180is/210is-MODEL A/B and Power Mate i-MODEL D/H 1. Communicate this report to : ○ Your information ○ GE Fanuc-N, GE Fanuc-E
  • Page 2Change of DeviceNet board Abstract In FS16i/18i/21i/160i/180i/210i/160is/180is/210is-MODEL A/B and Power Mate i-MODEL D/H, FANUC will apply the new DeviceNet board because parts on the board is stopped manufacturing. It is necessary to change the order specification and board number. Please pay atte
  • Page 33. Order specification for board Only board and software are changed. Other item and remarks on the Order List are not changed. a) FS16i/18i/21i/160i/180i/210i/160is/180is/210is-MODEL A/B Table 1 Old order Item New order specification Specification DeviceNet board Refer to Table 2. Control software
  • Page 4b) Power Mate i-MODEL D/H Table 3 Item Old order specification New order specification DeviceNet board Refer to Table 4. Control software A02B-0259-J554#6570 A02B-0259-J554#6571 (No changed) Application software A02B-0259-J553#6576 Since 04th edition. Master function A02B-0259-J860 (No changed) Slav
  • Page 54. Setting of parameter When the problem of excessive message traffic of the network occurs because new DeviceNet board was used, this problem can be avoided by adjusting the scanning interval of network. There is the item of “7 SCAN INTERVAL = “ on the DEVICENET MASTER SETTING screen to adjust the