
7. PARAMETERS FOR C–AXIS CONTROL
B–63130EN/01
40
#7 #6 #5 #4 #3 #2 #1 #0Address
16362 NRC CRM CMO G92 CNT CR0 RCO
Data type: Bit
RCO At reset, compensation of C–axis position is:
0: Not canceled.
1: Canceled.
CR0 When reference position return is performed for the C–axis:
0: Moves to the zero point of the machine coordinate system.
1: Moves to the zero point of the workpiece coordinate
system.
CNT If a T code with which turret indexing is not executed is
specified when the C axis is not at the reference point, the
machine is:
0: Moved along the C–axis to the reference point.
1: Not moved along the C–axis to the reference point. This
is validated when parameter CRM (No. 16362, #5) is set
to 0. The T code with which turret indexing is not executed
must be cataloged.
G92 G92 command for C–axis control is:
0: Invalidated.
1: Validated.
CMO In positioning for a C–axis command, a shift from the current
position to a specified position is executed:
0: In the direction in which the required rotation angle is
smaller.
1: Linearly.
CRM According to a T command,the machine is:
0: Moved along the C–axis to the reference point.
1: Not moved along the C–axis to the reference point.
NRC According to the command of automatic return to the reference
point (G28), the machine is:
0: Moved along the C–axis to the reference point.
1: Not moved along the C–axis to the reference point. This
is validated when parameter CRM (No. 16362, #5) is set
to 0.
#7 #6 #5 #4 #3 #2 #1 #0Address
16363 G91
Data type: Bit
G91 For C–axis control, a G91 command is:
0: Disabled
1: Enabled