
8. PARAMETERS FOR THE SAFETY ZONE
B–63130EN/01
50
#7 #6 #5 #4 #3 #2 #1 #0Address
16502 SOF ACZ SZ1 GSZ ZIO SZC MDP
Data type: Bit
MDP On the safety zone setting display,
0: The workpiece coordinate system is indicated.
1: The machine coordinate system is indicated.
SZC On the safety zone setting display, the data for:
0: Any zone can be changed.
1: Those zones to be set automatically (parameter 16534) can
be changed.
ZIO When the safety zone is automatically set by an external signal,
the position of a workpiece holder is detected according to:
0: The on and off states of the SAFZ signal used to detect the
position of a workpiece holder.
1: The on state of the SAFZ signal used to detect the position
of a workpiece holder.
GSZ On the graphic screen, the safety zone is checked according to
the position of a workpiece holder:
0: Specified on the safety zone screen.
1: Specified by graphic parameters.
(On the graphic screen, this check is executed in an area
that is not related to the actual machining check.)
SZI Data set on the safety zone setting display is:
0: Invalidated.
1: Validated.
ACZ The function used to prevent interference between workpiece
holders of:
0: Type A is used.
1: Type B is used.
SOF In the safety zone check, tool position compensation is:
0: Not considered.
1: Considered.