OPERATION
B–63094EN/02
8. DATA INPUT/OUTPUT
513
Pitch error compensation data are loaded into the memory of the CNC
from a floppy or NC tape. The input format is the same as the output
format. See
III–8.6.4. When a pitch error compensation data is loaded
which has the corresponding data number as a pitch error compensation
data already registered in the memory, the loaded data replaces the
existing data.
Pitch error compensation data
1 Make sure the input device is ready for reading.
2 When using a floppy, search for the required file according to the
procedure in III–
8.2.
3 Press the EMERGENCY STOP button on the machine operator’s
panel.
4 Press function key
OFFSET
SETTING
.
5 Press the soft key
[SETING] for chapter selection.
6 Enter 1 in response to the prompt for writing parameters (PWE).
Alarm P/S100 (indicating that parameters can be written) appears.
7 Press soft key
SYSTEM
.
8 Press the rightmost soft key
(next–menu key)and press
chapter selection soft key
[PITCH].
9 Press soft key
[(OPRT)].
10 Press the rightmost soft key
(next–menu key).
11 Press soft keys
[READ] and [EXEC].
Parameters are read into memory. Upon completion of input, the
“INPUT” indicator at the lower–right corner of the screen disappears.
12 Press function key
OFFSET
SETTING
.
13 Press soft key
[SETING] for chapter selection.
14 Enter 0 in response to the prompt for “PARAMETER WRITE
(PWE)” in setting data.
15 Turn the power to the CNC back on.
16 Release the EMERGENCY STOP button on the machine operator’s
panel.
Parameters 3620 to 3624 and pitch error compensation data must be set
correctly to apply pitch error compensation correctly (See
III–11.5.2).
8.6.3
Inputting Pitch error
compensation data
Procedure
Explanations
D Pitch error
compensation