
4. DESCRIPTION OF PARAMETERS
B–63090EN/02
78
1626
Time constant of exponetial acceleration/deceleration in the thread cutting cycle
for each axis
[Data type] Word axis
[Unit of data] ms
[Valid data range] 0 to 4000
Set the time constant used for exponential acceleration/deceleration in the
thread cutting cycle (G76, G78 (G92 in G code system A)) for each axis.
If the acceleration type is not exponential acceleration/deceleration,
parameter No. 1622 becomes valid.
1627
FL rate of exponential acceleration /deceleration in the thread cutting cycle for
each axis
[Data type] Word axis
[Unit of data]
[Valid data range]
Valid data range
ncremen
sys
em
n
o
a
a
IS-A, IS-B IS-C
Millimeter machine 1 mm/min 6 to 15000 6 to 12000
Inch machine 0.1 inch/min 6 to 6000 6 to 4800
Rotaion axis 1 deg/min 6 to 15000 6 to 12000
Set the lower limit (FL rate) of exponential acceleration/deceleration in the
thread cutting cycle (G76, G78 (G92 in G code system A)) for each axis.
1710
Minimum deceleration ratio (MDR) of the inner circular cutting rate in automatic
corner override
[Data type] Byte
[Unit of data] %
[Valid data range]
1 to 100
This parameter sets the minimum deceleration ratio (MDR) when the
inner circular cutting speed is changed by automatic corner override.
In circular cutting with an inward offset, the actual feedrate for a specified
feedrate (F) is expressed as follows:
Rc: Radius of the path of the cutter’s center.
Rp: Programmed radius
F
Rc
Rp
Then, the actual feedrate is controlled so that the feedrate on the
programmed path can achieve the specified feedrate F.