
APPENDIX
B–63604EN/01
G. ALARM LIST
729
Number ContentsMessage
096 P TYPE NOT ALLOWED (WRK OFS
CHG)
P type cannot be specified when the program is restarted. (After the au-
tomatic operation was interrupted, the workpiece offset amount
changed.)
Perform the correct operation according to th operator’s manual.
097 P TYPE NOT ALLOWED (AUTO
EXEC)
P type cannot be directed when the program is restarted. (After power
ON, after emergency stop or P/S alarm 94 to 97 were reset, no automat-
ic operation was performed.) Perform automatic operation.
098 G28 FOUND IN SEQUENCE
RETURN
A command of the program restart was specified without the reference
position return operation after power ON or emergency stop, and G28
was found during search.
Perform the reference position return.
099 MDI EXEC NOT ALLOWED AFT.
SEARCH
After completion of search in program restart, a move command is given
with MDI.
100 PARAMETER WRITE ENABLE On the PARAMETER(SETTING) screen, PWE(parameter writing en-
abled) is set to 1. Set it to 0, then reset the system.
101 PLEASE CLEAR MEMORY The power turned off while rewriting the memory by program edit opera-
tion. If this alarm has occurred, press <RESET> while pressing
<PROG>, and only the program being edited will be deleted.
Register the deleted program.
111 CALCULATED DATA OVERFLOW The result of calculation is out of the allowable range (–10
47
to –10
–29
,
0, and 10
–29
to 10
47
).
112 DIVIDED BY ZERO Division by zero was specified. (including tan 90°)
Modify the program.
113 IMPROPER COMMAND A function which cannot be used in custom macro is commanded.
Modify the program.
114 FORMAT ERROR IN MACRO There is an error in other formats than <Formula>.
Modify the program.
115 ILLEGAL VARIABLE NUMBER A value not defined as a variable number is designated in the custom
macro or in high–speed cycle cutting.
Modify the program.
116 WRITE PROTECTED VARIABLE The left side of substitution statement is a variable whose substitution
is inhibited. Modify the program.
118 PARENTHESIS NESTING ERROR The nesting of bracket exceeds the upper limit (quintuple).
Modify the program.
119 ILLEGAL ARGUMENT The SQRT argument is negative, BCD argument is negative, or other
values than 0 to 9 are present on each line of BIN argument.
Modify the program.
122 QUADRUPLE MACRO
MODAL–CALL
A total of four macro calls and macro modal calls are nested.
Modify the program.
123 CAN NOT USE MACRO COMMAND
IN DNC
Macro control command is used during DNC operation.
Modify the program.
124 MISSING END STATEMENT DO – END does not correspond to 1 : 1. Modify the program.
125 FORMAT ERROR IN MACRO <Formula> format is erroneous. Modify the program.
126 ILLEGAL LOOP NUMBER In DOn, 1x n x3 is not established. Modify the program.
127 NC, MACRO STATEMENT IN SAME
BLOCK
NC and custom macro commands coexist.
Modify the program.
128 ILLEGAL MACRO SEQUENCE
NUMBER
The sequence number specified in the branch command was not 0 to
9999. Or, it cannot be searched. Modify the program.
129 ILLEGAL ARGUMENT ADDRESS An address which is not allowed in <Argument Designation > is used.
Modify the program.