
APPENDIX
B–63604EN/01
G. ALARM LIST
745
No. DescriptionFaulty location and remedy
SPM
indica-
tion(*1)
Message
7n19 SPN_n_ : EX OFFSET
CURRENT U
19 Replace the SPM unit. Abnormality in an SPM component is
detected. (The initial value for the U
phase current detection circuit is ab-
normal.)
7n20 SPN_n_ : EX OFFSET
CURRENT V
20 Replace the SPM unit. Abnormality in an SPM component is
detected. (The initial value of the V
phase current detection circuit is ab-
normal.)
7n21 SPN_n_ : POS SENSOR
POLARITY ER-
ROR
21 Check and correct the parameters.
(No. 4000#0, 4001#4)
The polarity parameter setting of the
position sensor is wrong.
7n24 SPN_n_ : SERIAL
TRANSFER
ERROR
24 1 Place the CNC–to–spindle cable
away from the power cable.
2 Replace the cable.
The CNC power is turned off (normal
power–off or broken cable).
An error is detected in communica-
tion data transferred to the CNC.
7n26 SPN_n_ : DISCONNECT
C–VELO DE-
TECT
26 1 Replace the cable.
2Re–adjust the pre–amplifier.
The signal amplitude of the detection
signal (connector JY2) on the Cs con-
tour control motor side is abnormal.
(Unconnected cable, adjustment er-
ror, etc.)
7n27 SPN_n_ : DISCONNECT
POS–CODER
27 1 Replace the cable.
2Re–adjust the BZ sensor signal.
1 The spindle position coder (con-
nector JY4) signal is abnormal.
2 The signal amplitude (connector
JY2) of the MZ or BZ sensor is ab-
normal.
(Unconnected cable, adjustment
error, etc.)
7n28 SPN_n_ : DISCONNECT
C–POS DE-
TECT
28 1 Replace the cable
2Re–adjust the pre–amplifier.
The position detection signal (con-
nector JY5) for Cs contour control is
abnormal.
(Unconnected cable, adjustment er-
ror, etc.)
7n29 SPN_n_ : SHORTTIME
OVERLOAD
29 Check and correct the load status. Excessive load has been applied
continuously for a certain period of
time. (This alarm is issued also when
the motor shaft has been locked in
the excitation state.)
7n30 SPN_n_ : OVERCUR-
RENT POW
CIRCUIT
30 Check and correct the power supply
voltage.
Overcurrent is detected in PSM main
circuit input. (PSM alarm indication:
1)
Unbalanced power supply.
PSM selection error (The maximum
PSM output specification is exceed-
ed.)
7n31 SPN_n_ : MOTOR LOCK
OR V–SIG LOS
31 1 Check and correct the load status.
2 Replace the motor sensor cable
(JY2 or JY5).
The motor cannot rotate at a speci-
fied speed. (A level not exceeding
the SST level for the rotation com-
mand has existed continuously.)
Abnormality in the speed detection
signal.