GFK-1546 3 - 1
Chapter
Setting Parameters
The FANUC Serial Servo Bus (FSSB) system requires you to set the following parameters:
• Parameter No. 1023.
• Parameter No. 1905.
• Parameter No. 1910 – No. 1919.
• Parameter No. 1936 and 1937.
Setting Parameters
There are three ways to set these parameters:
1. Default setting.
2. Automatic setting.
3. Manual setting.
Note
Because of the limitations with the Default setting, it is recommended that you
use either the Automatic or Manual setting.
Default Setting
Setting the parameter in No. 1023 enables the default settings for the remaining parameters. You
do not need to set parameter No. 1905, 1910 – 1919, 1936, or 1937. However, the functions,
which you can then use, are limited.
3