2
1. General
When the cutting tool is changed by the manual operation, the tool offset value
(GecxMxic offset /Wear offset) can be changed to the offset value of a pertinent tool
@ inputting the tool number of the correspondence.
.
Details
.
~~~~~~~t~-~~-~~
input the tool offset number to the ~~1ua1 tool offset mxtiber signal m (GO68,Go69)
by PMC, and set the offset camMnd signal ~TK(Go67#0) to 1.
UK reads tool number, the tool offset value is changed to the specified tool offkt
value. When the offset value is ccxtpleted to be changed, the change ccqletion signal
(FO61#5) is turned on.
The tool is exchanged by the manual operation(operator).
+
Man.1 too1
I
offset number signal fi
MTw(FTK=>cNc)
Tool offset number
(Go68,cO69)
+
(Bcz) 4 digits)
Offset co~wkl signal
MTLC(PMC=>uVc)
(Go67#0)
Change completion
I
signal
I
I
TITLE
FSWUC Series 16i/'l8i-TA
. A&-tic alternation of tool
offset value specification
DRAW. NO.
CUST.
A-61105E
L
’ DESIG.
rx3scRIPTIm
SHEET
EDIT lIlzm3
FANUC L-T-D
m
I
n,
l?wLA (cNc=>FMc)
(FO61#5)
t
+
Change offset value (CNC)
me 1~1ua1 tool offset number signal m(Go68,Go69) is specified by BCD code 4 digits.
The selection which digit of 4 digits is used as a nuMber of the gmtric offset /the
wear offset follows the saw? rule as T code instruction at the automatic operation.
( Parameter LD~ (~0.5002#0) and LNG (No.5002#1) )