
B–63463EN/01
E. MEMORY CARD INTERFACE
APPENDIX
125
E
MEMORY CARD INTERFACE
The memory card interface at the front of the main unit can be used for
data input/output to and from the Digital Servo Adapter. This appendix
describes the specifications of the usable memory cards and provides
notes on their use.
SRAM cards that conform to any of the following standards can be used:
D TYPE 1 or TYPE2 4.0 or later, as defined by the Japan Electronic
Industry Development Association (JEIDA)
D TYPE1 or TYPE2 2.0 or later, as defined by the Personal Computer
Memory Card International Association (PCMCIA)
D PC Card Standard
SRAM cards operable only on 3.3 V cannot be used because they cannot
be physically inserted.
FANUC has checked the operation of the following FANUC–designated
SRAM cards:
1MB SRAM card Fujitsu MB98A91023–20
2MB SRAM card Fujitsu MB98A91123–20
NOTE
SRAM cards use a built–in battery to hold data, so they
should not be used for saving data for extended periods.
Series 2 flash memory cards from Intel Corp. (or equivalents) can be used.
As with SRAM cards, however, flash memory cards operable only on 3.3
V cannot be used because they cannot be physically inserted. Flash
memory cards using non–Intel flash memory as a built–in chip cannot be
used. When the flash memory card is formatted and written on a personal
computer, however, it may prove possible to read the card.
FANUC has checked the operation of the following FANUC–designated
flash memory card:
4MB flash memory card Fujitsu IMC004FLSA
Overview
SRAM cards
Flash memory cards