Ed.
Ed.Ed.
Ed. Date
DateDate
Date Design
DesignDesign
Design Description
DescriptionDescription
Description
Date
DateDate
Date 2003.03.07 Desig.
Desig.Desig.
Desig. Kageyama Apprv.
Apprv.Apprv.
Apprv.
111
131
FANUC Series 16i/18i/21i-TB/MB
SERVO GUIDE Mate Specification
-79087EN
Drawing No.
Title
Page
7 Warning Messages
Warning messages that is displayed with this function are as follows.
Message Description
THERE IS INVALID CHARACTER The one except for the numerical value was inputted.
(Input of a comment is removed.)
INPUT . OR – MORE THAN TWICE "." "-" was inputted more than twice.
TOO MANY DIGITS Four digits and more file NO. was inputted at the time of the Read/
comparison.
DATA IS OUT OF RANGE Value outside the range that it can be set up was inputted.
PLEASE CHANGE TO EDIT MODE Read/Punch/ comparison was carried out except for the EDIT mode.
NUMBER IS NOT REGISTERED There is no file specified at the time of file reading.
WRONG MODE It tried to do input except for the MDI mode.
MEMORY CARD ERROR : There is no memory card at the time of the Read/Punch/
comparison.
WRITE PROTECTED It can't be written in the memory card.
DATA IS OUT OF PICK There is no data of candidate which it was inputted from.
NOT CHOICE Though a candidate has it, it can't be chosen.
NOT SELECT DATA COUNT When measurement starts, a measurement data score isn't set up.
NOT SELECT CHANNEL NUMBER When measurement starts, settlement of a channel isn't being
done.
SETTING DATA IS MISMATCH When measurement starts, a setup data isn't consistent.
INDICATED TO SAMPLING START 'A start' was pushed during the measurement.
SETTING CHANNEL DATA ERROR When measurement starts, it is short of the number of setup
channels.
DATA NOT FOUND A file format doesn't correspond by the Read/Punch/ comparison.