
EDIT.
SHEET
DRAW. NO.
CUST.
TITLE
14
30
DESCRIPTION DESIG. DATE
FANUC PANEL i
Maintenance Manual
-83138E
4.3. How to Begin the ‘BIOS SET-UP’
1. Finish working and store the data.
2. Turn off and connect a full-keyboard, and turn on again.
3. BIOS set-up will run with pressing “F2” key while “Press <F2> to enter SETUP.” is displayed.
4. Menu screen is displayed. Change parameters if it is necessary.
Initial screen (At normal booting)
4.4. How to End the ‘BIOS SET-UP’
Changed settings become effective after saving settings and restarting the system.
Select either one of the following methods for saving and restarting.
(Method 1) : Set Exit mode by pressing ESC key or selecting “EXIT” item.
Then select “Exit Saving Changes” and press ENTER key.
(Method 2) : Press F10 key then message as “Save Configuration changes and exit now?” is displayed. Select “Yes” .
If you want to discard changes and restart the system, do as follows.
Set Exit mode by pressing ESC key or selecting “EXIT” item.
Select “Exit Discarding Changes” and press ENTER key.
PhoenixBIOS 4.0 Release 6.0
Copyright 1985-1999 Phoenix Technologies Ltd.
ll rights Reserved
FANUC BIOS, 6150/03
Copyright 2002, FANUC LTD
ll rights Reserved
CPU = Intel (R) Pentium(R) III processor 866MHz
640K System RAM Passed
127M Extended RAM Passed
System BIOS shadowed
ideo BIOS shadowed
Fixed Disk 0 : -----
Press <F2> to enter SETUP
BIOS edition
CPU