B--63005EN/02
5. INPUT AND OUTPUT OF DATA
415
The machining program punched out by applying the proceduredescribed
on the previous page can be read into the NC via a reader/punch interface.
Before attempting to read a program, release the memory protect switch
on the machine operator’s panel.
After switching to EDIT mode, display the registered program list screen
for editing, then press [READ]. The following message prompting the
user to input the file number is displayed, as well as the soft keys used to
confirm operation.
<
EXE
C
CAN-
CEL
PROGRAM NO. = →SFTKY
INITAL SET FC25 BAR
PROC(01) BAR OUTER END
PROC(02) BAR OUTER END
PROC(03) TRANS
PROC(04) BAR OUTER END
PROC(05) BAR OUTER END
ROUGH T0505
FIN T0505
ROUGH T0505
FIN T0505
HEAD--L
HEAD--L
HEAD--R
HEAD--R
Enter the number of the file containing the machining program to be input,
using numeric keys, then press [EXEC]. Reading of the machining
program starts. When the input device is FANUC PPR, press [EXEC]
without inputting a file number.
When [CAN] is pressed, read operation is canceled and the previous state
is restored.
Upon the start of inputting machining programs, “INPUTTING” blinks
at the bottom of the screen, until the input operation ends.
NOTE
Only a machining program created with the conversational
input function can be input by applying the above
procedure.
A machining program created using the NC program screen
cannot be input by applying the above procedure.
Input of conversational
machining programs