1.MANUAL GUIDE 0i MANUAL GUIDE 0i B-63844EN/02
- 760 -
1.5.3.5 Arc that Contacts to Uncrossing Line and Arc
By inputting three successive figures as follows, arc (2) that is
tangential to line (1) and arc (3) that do not cross, can be specified as
shown in the above drawing. The end points of (1) and (2) are
determined, while (3) is left pending.
Among the multiple possible arcs shown above, the arc that makes the
smoothest connection to line (1) and arc (3) is automatically selected.
But, even though a "Long path arc" and "Short path arc" remain,
select whichever is necessary from the selection screen.
Line (1) :
Line that is pending (for which A is inputted and the start point
has been determined)
Arc (2) :
R and "TOUCH LAST" are inputted.
Arc (3) :
Arc with R, I and J
(3)
(1)
R
(2)
Tangential
point
Tangential
point