OPERATION8. DATA INPUT/OUTPUT
B–63614EN/01
536
15 Turn the power to the CNC back on.
16 Release the EMERGENCY STOP button on the machine operator’s
panel.
All parameters are output in the defined format from the memory of the
CNC to a floppy or NC tape.
Outputting parameters
1 Make sure the output device is ready for output.
2 Specify the punch code system (ISO or EIA) using a parameter.
3 Press the EDIT switch on the machine operator’s panel.
4 Press function key
SYSTEM
, then the parameter screen appears.
5 Press chapter selection soft key
[PARAM].
6 Press soft key
[(OPRT)].
7 Press rightmost soft key
(next–menu key).
8 Press soft keys [PUNCH].
9 To output all parameters, press the [ALL] soft key. To output only
parameters which are set to other than 0, press the [NON–0] soft key.
10 Press soft key
[EXEC].
All parameters are output in the defined format.
Output format is as follows:
NP ;. . . . . . .
N A1P A2P AnP ;. . . . . . . .
NP ;. . . . . . .
N : Parameter No.. . .
A : Axis No.(n is the number of control axis). . .
P : Parameter setting value .. . .
To suppress the output of the following parameters, press the [PUNCH]
soft key then [NON–0] soft key.
Other than axis type Axis type
Bit type Parameter for which all bits
are set to 0
Parameter for an axis for
which all bits are set to 0.
Value type Paramter whose value is 0. Parameter for an axis for
which the value is 0.
When the floppy disk directory display function is used, the name of the
output file is PARAMETER.
Once all parameters have been output, the output file is named ALL
PARAMETER. Once only parameters which are set to other than 0 have
been output, the output file is named NON–0. PARAMETER.
8.6.2
Outputting Parameters
Procedure
Explanations
D Output format
D Suppressing output of
parameters set to 0
D Output file name