PROGRAMMING14. COMPENSATION FUNCTION
B–63604EN/01
192
Whether specifying T00 alone, while tool position offset is applied,
cancels the offset depends on the settings of the following parameters:
When the tool geometry/wear compensation option is selected
LGN = 0
LGN (No.5002#1) LGT (No.5002#4) LGC (No.5002#5)
The geometry offset number is:
0: Same as the wear offset
number
1: Same as the tool selection
number
Geometry compensation is applied:
0: Based on shift of the
coordinate system
1: Based on movement of the tool
The geometry offset is:
0: Not canceled with T00
1: Canceled with T00
Result
LGT=0
LGT=0 LGC=0
LGC=1
Not canceled
Canceled
LWM (No.5002#6)
Tool position offset is applied:
0: By means of T code
1: By means of movement
along axis
LGT=1 LWM=0
LWM=1
Canceled
Not canceled
NOTE
1 When LGT=0, LWM is unrelated.
2 When LGT=1, LGC is unrelated, even when LGN = 0.
LGN = 1
LGN (No.5002#1) LGT (No.5002#4) LGC (No.5002#5)
The geometry offset number is:
0: Same as the wear offset
number
1: Same as the tool selection
number
Geometry compensation is applied:
0: Based on shift of the
coordinate system
1: Based on movement of the tool
The geometry offset is:
0: Not canceled with T00
1: Canceled with T00
Result
LGT=0
LGT=0 LGC is unrelated. Canceled
LWM (No.5002#6)
Tool position offset is applied:
0: By means of T code
1: By means of movement
along axis
LGT=1 LWM=0
LWM=1
Canceled
Not canceled
NOTE
1 When LGT = 0, LWM is unrelated.
2 When LGT = 1, LGC is unrelated.
D Canceling tool position
offset with T00